16 – English
ASSEMBLY
8 Tension the belt with the belt adjuster.
9 Fit the front cover.
10 Set the cutting deck height control in any of the positions
1-5.
Removing the cutting unit
The cutting deck can be removed in order to facilitate cleaning
and servicing.
To remove the cutting deck proceed as follows:
1 Position the machine on flat ground.
2 Apply and lock the parking brake.
3 Check that the lever for setting the cutting height is in the
S position.
4 Lower the cutting deck to the mowing position.
5 Remove the front cover.
6 Disengage the spring for the drive belt tensioning wheel.
7 Remove the pin in the equipment frame. Grab the upper
pipe constr
uction of the deck and pull it out.
Assembling the mulcher plugs
• Fit the mulching plug in place.
2
2
1
2
1
2
To Next Page
