33
130117
45. Press the key for 3 - 5 seconds. “AM
TOO COOL” and “AM FOLDED EGGS -
CLAM” will be displayed on the control
screen.
46. The screen will then display, “CLEAN
GRILL SURFACES,” followed by “CLOSE
PLATEN FOR AUTO LEVELING.”
47. Using a sundae spoon, distribute two level
spoonfuls of soy adhesion flakes over a
warm 3 ft. (1 m.) lower grill surface,
allowing the flakes to melt.
(See Figure 72.)
Figure 72
48. Using a clean squeegee, spread the
flakes on the cooking zone.
(See Figure 73.)
Figure 73
49. With the narrow side of the lower release
sheet facing the back of the grill, hold the
release sheet about one inch from the
end of each side. Align the back edge of
the release sheet with the back splash
and the side edge of the grill.
(See Figure 74.)
Figure 74
50. Using the grill squeegee, gently squeegee
out air bubbles, making sure not to crease
or fold the release sheet. (See Figure 75.)
Figure 75
51. Repeat the last two steps for the
release sheet on the other side of the
grill. (See Figure 76.)
Figure 76