2. Select Tuner station presets or relay
operation on the HC-1 Home Controller. First
press the HOME pushbutton (4) and then the
desired pushbuttons 0 through 9 (2) within
five seconds to activate the relays on the
HC-1.
The number pushbuttons also function
with the RCT-1 Remote Control Translator,
when it is programmed to allow the C39 to
remotely control other brand products.
3. Select CD Player, CD Changer or tape
recorder functions.
Using a Mcintosh a SINGLE DISC CD
PLAYER, STOP, BACK TRACK ( ), NEXT
TRACK ( ) and PLAY functions can be
performed.
Using a Mcintosh CD CHANGER, STOP,
BACK TRACK ( ), NEXT TRACK ( )
and PLAY functions can be performed while
a disc is playing.
When the CD changer is in the STOP position, BACK TRACK ( ) selects the SINGLE
DISC and NEXT TRACK ( ) selects which of the other six discs you wish to play. After
pressing STOP, the first time you press NEXT ( ), disc number 1 is selected. Press again
as desired to select discs 2 through 6.
FOR EXAMPLE: To select disc number 6 from the single disc play mode, press STOP and
then NEXT ( ) six times. To select disc number 2, press STOP and then press NEXT ( )
twice. To select the disc in the SINGLE disc slot, press STOP and then press BACK ( ) once.
4. Press HOME to operate the HC-1 Home Controller functions. Within five seconds press
a pushbutton number from 0 to 9 to control the desired relays on the HC-1,
5. Press SYS OFF to turn the entire C39 system off from either Area "A" or Area "B" after
the SYS OFF is activated.
6. Press POWER to turn on the main system in Area "A". Press in Area "B" to turn on just
Area "B" Outputs and power amplifier. Each time Area "B" is turned on, the TUNER input
is automatically selected at a volume level 50dB below maximum. The Area "A" power amplifier
and dedicated Area "B" power amplifier AC power cords must be connected to or controlled
by their respective C39 rear panel Area "A" and Area "B" AC outlets.
7. Select Tuner functions of AM, FM or SEEK. When an RCT-1 Translator is being used to
control a TV set, the SEEK UP or DOWN pushbuttons can be used to change TV channels.
8. First press TUNER and then press REVIEW to start the automatic audition of each of the
preset stations stored in tuner memory of a compatible Mcintosh tuner. Press REVIEW again
to stop on the desired preset. Cancel the REVIEW process by pressing REVIEW a second
time, or pressing any other Tuner function pushbutton.
9. E (ENTER or EXTRA) is used for controlling functions of an accessory component when
an RCT-1 Remote Control Translator is being used.
14
C39
HAND HELD
REMOTE
CONTROLLER
To Next Page
Loading...
