McIntosh C712 User Manual

C712 HAND HELD
REMOTE
CONTROLLER
HOW TO INSTALL BATTERIES IN THE C712 HAND HELD REMOTE CONTROLLER
Slide open the battery compartment. Insert two type AAA batteries into the
compartment, making sure to observe the battery polarities indicated in the battery
compartment.
When the batteries are nearing exhaustion, the effective range of the remote
controller decreases, and MAY even fail to operate. In this case, replace both
batteries with fresh ones.
NOTE:
1. Do not mix old and new batteries. Use ONLY batteries that are new.
2. Make sure both batteries are of the same type and identical.
3. To prevent damage caused by possible battery leakage, remove the batteries from
the remote controller if it is not going to be used for an extended period of time.
4. Never dismantle batteries or dispose of them in a fire, as they may explode.
Dispose of old batteries in an approved method for proper safety.
SPECIFICATIONS
FRQUENCY RESPONSE
+0, -0.5dB from 20Hz to 20,000Hz
RATED OUTPUT
2.5V at BALANCED and MAIN
(Unbalanced) OUTPUTS
MAXIMUM VOLTAGE OUTPUT
8V from 20Hz to 20,000Hz at
BALANCED and MAIN (Unbalanced)
OUTPUTS.
TOTAL HARMONIC DISTORTION
0.002% maximum from 20Hz to
20,000Hz at rated output.
SENSITIVITY
Phono: 2.5mV for 2.5V rated output,
(0.5mV IHF).
High Level: 250mV for 2.5V rated
output, (50mV IHF).
SIGNAL-TO-NOISE RATIO,
A-Weighted
Phono: 90dB below 10mV input, (84dB
IHF).
High Level: 105dB below rated output,
(95dB IHF).
MAXIMUM INPUT SIGNAL
Phono: 90mV
High Level: 10V
INPUT IMPEDANCE
Phono: 47K ohms and 65pF Capacitance
High Level: 22K ohms
VOLTAGE GAIN
Phono to Tape: 40dB
Phono to Main: 60dB
High Level to Tape: 0dB
High Level to Main: 20dB
TONE CONTROLS
Bass and Treble, variable 12dB boost
to 12dB cut.
AC POWER OUTLET
One Switched; Total current capacity
11.6 amperes, (1400 watts)
MECHANICAL
SIZE
Front Panel measures 17-1/2 inches
(44.5cm) wide by 3-5/8 inches (9.2cm)
high. Chassis depth behind the mounting
panel including clearance for connectors
is 17-1/2 inches (44.5cm). Knob
clearance required in front of mounting
panel is 1-1/8 inches (2.9cm).
FINISH
Front Panel is glass with gold/teal
nomenclature illumination. The chassis is
black.
WEIGHT
17 lbs. (7.7Kg) net, 29 Ibs. (13.2Kg) in
shipping carton.
12

McIntosh C712 Specifications

General

Brand	McIntosh
Model	C712
Category	Control Unit
Language	English