McIntosh MA6400

The descriptions and functions of the MA6400 Remote Controller pushbuttons refer to the
numbers on the drawings. Several operating functions are designed to be used when the
optional RCT-2 Remote Control Translator is added to the MA6400. The RCT-2 is a learning
device which allows the MA6400 to remotely control other brands of compatible accessories.
SPECIAL NOTE:
The pushbuttons marked In black do not function with the MA6400. They function only
when this Remote Controller Is used with another Mclntosh model.
1. Select input signals for CD1, CD2. TUNER. PHono/AUX or VIDEO.
2. Press MON 1 or MON 2. (Tape Monitor), to listen to playback of tapes from either of two tape
recorders. You can listen to previously recorded tapes, or monitor tape from a three-head tape
recorder during the recording process. A Red LED will turn ON above either of the MA6400
front panel pushbuttons to indicate whether (Tape) MON 1 or MON 2 has been selected.
3. Select additional audio/video program signal sources when the optional MVS-3 Audio/Video
Selector is added to the MA6400 system. First press the Remote Controller VIDEO pushbutton
and then within 3 seconds, press the desired pushbutton for any of the five audio/video signal
sources connected to the MVS-3.
4. Select Mclntosh CD Player or CD Changer operating functions.
10
5. Press the SYS OFF pushbutton to turn the entire MA6400 system OFF.
If the optional Mclntosh RCT-2 Remote Control Translator is used with the MA6400, these
pushbuttons could operate another brand CD player or a tape recorder.
) once.
) twice.
To select the disc in the SINGLE disc slot, press STOP and then press BACK (
) six times. To select disc number 2, press STOP and then press NEXT (
then NEXT (
select discs 2 through six.
FOR EXAMPLE: To select disc number 6 from the single disc play mode, press STOP and
), disc number 1 is selected. Press again as desired to STOP, the first time you press NEXT (
and NEXT TRACK ( ) selects which of the other six discs you wish to play. After pressing
) selects the SINGLE DISC
functions can be performed while a disc is playing.
When the CD changer is In the STOP position, BACK TRACK (
Using a Mclntosh CD CHANGER. STOP. BACK TRACK (
), NEXT TRACK (
) and PLAY
)
), NEXT TRACK (
Using a Mclntosh SINGLE DISC CD PLAYER. STOP. BACK TRACK (
and PLAY functions can be performed..
MA6400
HAND HELD
REMOTE
CONTROLLER