Need help?Do you have a question about the McIntosh MA6400 and is the answer not in the manual?
General| Power Output | 100 watts per channel |
|---|---|
| Frequency Response | 20 Hz to 20 kHz |
| Total Harmonic Distortion (THD) | 0.005% |
| Input Sensitivity (Phono) | 2.5mV |
| Signal to Noise Ratio (Phono) | 80 dB |
| Signal to Noise Ratio (High Level) | 100 dB |
| Damping Factor | 100 |
| Input Impedance (line) | 20k Ohms |
| Input Impedance (MM) | 47k Ohms |
| Output Impedance | 4 Ohms |
Adjusts bass and treble frequencies for audio output.
Displays peak power output in watts and decibels.
Indicates activation of the Power Guard circuit for clipping prevention.
Controls listening volume and mutes audio output.
Adjusts channel balance and provides loudness compensation.
Receives infrared signals from the remote controller.
Controls tape playback monitoring and copying between recorders.
Connects headphones and selects audio input sources.
Combines left and right channels for mono playback.
Selects which speaker pairs are active.
Turns the MA6400 system on and off.
Describes functions for input selection, CD control, and tuner operations.
Instructions for inserting and replacing batteries in the remote.
Connects CD players, accessories, and control translators.
Links to external power amps and provides main outputs.
Connects tape decks and external signal processors.
Accepts signals from video, tuner, CD, and auxiliary sources.
Connects turntables and provides ground connection.
Connects to power; provides switched/unswitched outlets.
Connects loudspeakers to the amplifier.
Connects remote sensors and accessory power control devices.
Details design principles, protection, and thermal control.
Explains clipping prevention, logic control, and switching.
Describes phono, loudness, and tone control amplifier designs.
Details stereo power output, rated band, and frequency response.
Covers THD, IMD, headroom, and signal-to-noise ratio.
Specifies input requirements, impedance, and tone control range.
Lists unit dimensions, finish, and weight.
To Next Page