EasyManua.ls Logo

McIntosh MAC 4200

McIntosh MAC 4200
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
been charged. The charge rate is dictated by the time the
receiver is turned 'on' without regard to the mode of
operation. For instance the batteries will charge should
you wish to play records, or tape on FM. To bring the
batteries to full charge, operate for twenty-four con-
tinuous hours. When fully charged, and with the receiver
turned off the programmed instructions will be retained
for more than six months. After the batteries are fully
charged, use for approximately one hour per week, will
maintain the batteries in a fully charged state.
MANUAL
A momentary press of the MANUAL feathertouch-button
will activate the manual tuning knob and the red indicator
above the knob will turn on. Rotate the tuning knob until
the frequency of the desired station shows in the station
display area.
A station is correctly tuned when the center vertically
displayed ( ) arrow at the bottom of the SIGNAL/TUNING
display, lights. On each side of the center arrow are
horizontaly displayed ( ) arrows. One of these will
light as a station is approaced to indicate tuning above or
below the center frequency of the FM station. FM stations
broadcasting in stereo light the FM MPX bar indicator
above the SIGNAL/TUNING indicator.
An AM station is correctly tuned when the center (ver-
tically displayed) arrow at the bottom of the SIGNAL/TUN-
ING display lights. On AM, the horizontally displayed ar-
rows do not function.
A momentary press on any of the numbered
feathertouch-buttons or SCAN activates that tuning
method selected and deactivates the manual tuning knob.
SCAN
Use the SCAN feathertouch-button to automatically tune
to the next station either up or down the broadcast band
selected. The arrow beside the feathertouch-button in-
dicates the direction of the scan. When a remote scan
cable/switch is inserted in the rear panel receptacle, a
momentary press of the remote button will activate the
tuner scan-up circuit. The remote scan cable/switch
assembly, (Mclntosh Part No. 045-515) can be obtained
from your Mclntosh dealer.
FRONT PANEL CONTROLS 13

Related product manuals