15
How to Operate the Remote Control
How to Operate the Remote Control
Input Selection
Press the INPUT Push-button followed by pressing one of
the NUMBERED Push-button (1-7) to select the desired
digital input on the MDA1000.
Note: Remote Control Selection of Digital Inputs can also
occur using the Remote Control supplied with a
McIntosh Preamplifier, Audio Control Center, A/V
Control Center, A/V System Controller, Audio/Video
Multizone Control System or Integrated Amplifier. This
requires the MDA1000’s DATA IN Jack be connected to
a Data Port on that component. Using the Remote
Control supplied with those components, press the
REVIEW Push-button followed by the pressing one of
the NUMBERED Push-buttons (1-7) to select the
desired digital input.
Volume Level
The MDA1000 offers either a fixed volume level (default
setting) or a variable volume level at the Audio Output
Jacks. If the variable volume level has been selected in the
Setup Mode (refer to page 12), use the LEVEL UP (+) or
DOWN (-) Push-button on the remote control to adjust the
MDA1000 Volume level.
To Next Page
Loading...
