McIntosh MEN220

23
FACTORY RESET:
1. Press the MENU Push-button to enter the Setup
Mode. Refer to figure 16 on page 18.
2. Rotate the NAVIGATE Control (or use the Direc-
tional ▲ ▼ Push-buttons on the Remote Control)
to select “Advanced Settings”. Refer to figure 50.
3. Press the SELECT Push-button and the “Advanced
Settings, Remote Control” will appear. Rotate the
NAVIGATE Control (or use the Directional ▲
▼ Push-buttons on the Remote Control) to select
“Factory Reset”. Refer to figure 59.
4. Press the SELECT Push-button and the “Delete
All Settings?, No” will appear. Refer to figure 60.
5. Rotate the NAVIGATE Control (or use the Direc-
tional ▲ ▼ Push-buttons on the Remote Control)
to select “Delete All Settings?, Yes”. Refer to
figure 61.
6. Press the SELECT Push-button and figure 59 will
appear briefly. The MEN220 will switch Off.
7. Press the STANDBY/ON Push-button on the Front
Panel or press the (Power) Push-button on the
Remote Control to switch On the MEN220.
5. Rotate the ADJUST Control to select the desired
Display Intensity. Refer to figure 56.
SOFTWARE VERSION:
1. Press the MENU Push-button to enter the Setup
Mode. Refer to figure 16 on page 18.
2. Rotate the NAVIGATE Control (or use the Direc-
tional ▲ ▼ Push-buttons on the Remote Control)
to select “Advanced Settings”. Refer to figure 50.
3. Press the SELECT Push-button and the “Advanced
Settings, Software Version” will appear. Refer to
figure 57.
4. Press the SELECT Push-button and the “McIn-
tosh SW Version: _._ _ ” will appear. Refer to
figure 58.
be disabled to prevent possible interference. To de-
activate the MEN220 Front Panel Sensor perform the
following steps:
5. Rotate the ADJUST Control to switch Off the
Front Panel Remote Control Sensor. Refer to fig-
ure 53.
DISPLAY:
1. Press the MENU Push-button to enter the Setup
Mode. Refer to figure 16 on page 18.
2. Rotate the NAVIGATE Control (or use the Direc-
tional ▲ ▼ Push-buttons on the Remote Control)
to select “Advanced Settings”. Refer to figure 50.
3. Press the SELECT Push-button and the “Advanced
Settings, Display” will appear. Refer to figure 54.
The MEN220 Front Panel Information Display Inten-
sity has four different settings 100% (default), 75%,
50% and 25%. To change from the default setting
perform the following:
4. Press the SELECT Push-button and “Display In-
tensity, 100%” will appear. Refer to figure 55.
Figure 53
Front Panel Sensor
Off
Display Intensity
100%
Figure 55
Display Intensity
50%
Figure 56
Advanced Settings
< Display >
Figure 54
Advanced Settings
< Software Version >
Figure 57
Figure 58
McIntosh MEN220
SW Version: _.__
Advanced Settings
< Factory Reset >
Figure 59
Figure 60
Delete All Settings?
No
Figure 61
Delete All Settings?
Yes
Setup, con’t