34
Packing the MX123
When shipping the MX123, it is highly recommended
that the unit be packed as it was originally shipped to
avoid damage. Failure to properly pack the unit will
likely result in damage. (The front panel is made of
glass!) If you need any of the packing material, you
can contact McIntosh Customer Service. Use only
packing material that is in good condition and replace
any material that has seen better days.
It is very important that the four plastic feet are
attached to the bottom of the equipment. This will
ensure the proper equipment location on the bottom
pad. Failure to do this will result in shipping damage.
Quantity Part Number Description
1 034256 Shipping carton only
4 033887 End cap
2 034493 Spacer pad
1 033697 Inside carton only
1 033725 Inner carton top pad
1 034576 Bottom pad
2 034446 Foam plug
4 017937 Plastic foot
4 400159 #10-32 x 3/4” screw
4 404080 #10 Flat washer
1 034499 Accessory Box
2 034500 Slotted foam
1 034501 Divider foam
SPACER
PADS
SLOTTED
FOAM (2)
DIVIDER
FOAM
ACCESSORY
BOX
MICROPHONE
STAND
MICROPHONE
MINI BOOM
MICROPHONE
CABLE
BACK
INPUT
VOLUME
TRIM SELECT
SURROUND MODE
DISPLAY
MODE
LATE
NIGHT
STANDBY / ON
SET UP
HDMI
INPUT FORMAT OUTPUT FORMAT
ANALOG SIGNAL
DIGITAL SIGNAL
SUB
RBS
RL C
BSLBS
LFE
RL C
S
RSLSRSLS
RBSLBS
ADJUST
SELECT
ZONE B
CONTROL
NAVIGATE
ROOMPERFECT
HD AUDIO
MX1 5 0 A
/
V CO N TR O L C E NT ER
FOAM PLUG (2)
Figure 28– Re-packing diagram
To Next Page
Loading...
