DRIVING CONTROLS
HANDLING AND POWERTRAIN CONTROLS
77
3. Press the LAUNCH button (arrowed).
NOTE: L will flash in the gearbox
mode indicator, see Manual/Automatic
mode, page 68.
4. With your left foot remaining on the brake
pedal, press and hold the accelerator pedal
down fully with your right foot, the engine
speed will increase to 3000 rpm.
NOTE: To abort launch control release
the brake pedal before pressing the
accelerator pedal or wait for approximately
60 seconds until launch control is
deactivated.
5. Release the brake pedal with your left foot
and the launch control system will perform a
launch start to give maximum acceleration
NOTE: To abort launch control release
the accelerator pedal or wait for
approximately 5-10 seconds until launch
control is deactivated. If the launch is
aborted, release the accelerator pedal and
then press again to drive away.
6. Launch control will operate until aborted.
NOTE: Whilst in launch control, the
vehicle will carry out automatic gear
shifts, and optimise traction. It will continue
to do so until launch control is aborted. To
abort launch control, release the
accelerator pedal, apply the brake, or
operate one of the gearshift paddles.
S
N
T
AERO
S
N
T
MANUAL
WINTER
LAUNCH
ACTIVE
P
START
ENGINE
STOP
To Next Page
Loading...
