MCOHome MH-F500 User Manual

to heat or cool based on the desired fixed indoor temperature
Z-Wave
Configuration
Press “Menu”→“Next”(press twice)→ “SETUP
ID. If inclusion is succeeded
, a node ID will display on the
A node ID can always inform us whether the device is in the network or not.
Set schedule
The device
provides 4 times periods each day/7days for both heating and cooling status.
Press “Menu”→“Next”(press 3
times)→“SCHEDUL SET”→“Edit”→Pre
to set heating or cooling schedules.→Next→MONDAY 06:00
time→“Next”→78℉(Blinking)→”+ or
period start time→“Next”→62℉(Blinking)→”+ or
change the 3
rd
period start time→“Next”→70℉(Blinking)→”+ or
→”+ or -”to change the 4
th
period start time→“Next”→70℉(Blinking)→”+ or
06:00...
Then follow the same procedure
to do the sc
to the main interface. Please check the following figures:
Menu-WORKING MODE
5
to heat or cool based on the desired fixed indoor temperature
until the working mode is changed.
Configuration
Press “Menu”→“Next”(press twice)→ “SETUP
Zwave”→“Edit”→”+”.
Device will enter learning mode to get a
, a node ID will display on the
screen in a few seconds. →Press “Done”
A node ID can always inform us whether the device is in the network or not.
Set schedule
provides 4 times periods each day/7days for both heating and cooling status.
times)→“SCHEDUL SET”→“Edit”→Pre
ss to select HEAT or COOL under
to set heating or cooling schedules.→Next→MONDAY 06:00
（blinking）→”+ or -”to c
hange the 1
time→“Next”→78℉(Blinking)→”+ or
-”to set the desired temp.→“Next”→08:00（
blinking
period start time→“Next”→62℉(Blinking)→”+ or
-
”to set the desired temp.→“Next”→18:00
period start time→“Next”→70℉(Blinking)→”+ or
-
”to set the desired temp..→“Next”→22:00
period start time→“Next”→70℉(Blinking)→”+ or
-
”to set the desired temp.→ TUESDAY
to do the sc
hedule setting. Finally, press “Done” to save all the settings and return back
to the main interface. Please check the following figures:
SCHEDULE MODE
until the working mode is changed.
Configuration
Device will enter learning mode to get a
node
screen in a few seconds. →Press “Done”
.
Set schedule
ss to select HEAT or COOL under
Mode area
hange the 1
st
period start
blinking
）→”+ or -”to change the 2
nd
”to set the desired temp.→“Next”→18:00
（blinking）→”+ or -”to
”to set the desired temp..→“Next”→22:00
（blinking）
”to set the desired temp.→ TUESDAY
hedule setting. Finally, press “Done” to save all the settings and return back
HOLD MODE

MCOHome MH-F500 Specifications

General

Brand	MCOHome
Model	MH-F500
Category	Thermostat
Language	English