R410A 60Hz 16 SEER Universal Outdoor Series Technical Manual
the remote controller,
no " beep " sound
comes from the indoor
unit and the RUN light
is off
Fuse of power switch may have burned
The creepage switch is off
Turn on the creepage switch
The remote controller is working out of
the function range
Operate the remote controlle, in the function
range of the remote controller
Batteries of remote controller exhausted
(Information on the screen darken)
Replace them with new batteries
Air conditioner fails to start
Remote controiler
indicates that the air
conditoner is working
Be in 3 minutes protection of compressor
Wait or call your dealer for service
After starting up, the air
conditioner will stop working
in a short time
Air inlet or outlet of the indoor or outdoor
unit are blocked
Eliminate all dirties and make air smooth
Air flow is normal but the air
blew out is not cool or warm
Remote controller
indicates that the air
conditoner is working
Temperature is not set correctly, too high
in COOL mode or too low in HEAT mode
Set the temperature properly
The air filter net has been blocked with
dust or dirt
Air inlet or outlet of the indoor or outdoor
unit are blocked
Eliminate all dirties and make air smooth
Doors and windows are open
Note: Once the air conditioner break down for power failure, it can start only by pressing “ON/OFF” key on the
remote controller even if the power restores.