MCS 6710 - Safety Precautions and Warnings; General Safety Guidelines

Never connect the AC power plug before assembly has
been completed.
@ Do not grasp or hold the tonearm during operation of
the automatic mechanism.
M Never set the “program” knob or touch the tonearm
during automatic cycle (auto-start, auto-stop or change
cycle).
Wait until the tonearm has returned to the arm rest, or has
descended to the record and resumed play.
@MRecords having sizes other than 17 cm and 30 cm (7”
and 12’’) should be played manually.
Your turntable is designed for automatic handling of records
that adhere to accepted industry dimensions. Therefore,
use the unit manually for records other than standard sizes.
Note:
Warped records or those especially thinner or thicker than
standard should also be played manually only.
If such records are used for multiple-play operation, two
records may drop simultaneously, or the record may not
drop at all.
Min the case of multiple-play, be sure to use records of
the same size.
@ Use the cueing lever only for single-play operation (one
record only).
@ Power source
It is very dangerous to use this unit at a voltage which is
different from the rated voltage.
There is danger of combustion if the unit is connected to a
power source which is different from the rated voltage.
Be very careful concerning this point.
The correct voltage for this turntable is 120 V AC, 60 Hz.
@ Direct current cannot be used.
There are some places, such as ships, where direct current
is used as the power source. Before connecting the unit,
confirm the power source.
Connection of power cord.
Wet hands are dangerous.
Be sure to never touch the power cord with wet hands
because there is danger of electric shock. This is true, of
course, of all electric equipment.
MNever pull the power cord to disconnect it. Always pull
the plug of the cord only.
Location of unit.
Choose a place which is not in direct sunlight.
Select a place which will assure good ventilation.
M Never place heating equipment nearby.
Be sure to keep stoves and other sources of heat away from
this unit, because heat radiated by such equipment may
cause deformation of plastic parts or damage the cabinet,
or, at worst, cause a fire.
M Especially for families with children.
Take care that no small items, such as metal objects, are
put inside this unit.
In addition, children should be especially warned not to put
anything into the ventilation holes, such as toys or a screw-
driver, because these things may cause an electric shock or
result in a malfunction of the unit.
Wilf water spills on the unit.
If water should happen to spill on the unit, from an over-
turned vase for example, there is danger of fire or electric
shock. Disconnect the power plug from the electric outlet
immediately, and contact the store from which the unit was
purchased.
Reconstruction can cause accidents.
Absolutely never try to remodel, reconstruct or repair this
unit yourself. Do not attempt to touch any internal parts
because to do so may result in an electric shock or other
accident.
@ Be sure the power is off.
After you have finished using this unit, check once more to
be sure that the power is off. If the unit is left with the power
on for along period of time, it may not only be damaged, thus
shortening its useful life, but may also lead to a dangerous
accident.