MCS 6710 - Dust Cover and Placement Instructions; Turntable Placement Recommendations; Electrical Connections

5. After adjusting the horizontal zero (0) balance, turn
the balance weight in the direction of the arrow and
align to the correct stylus pressure.
(See Fig. 6.)
(The stylus pressure of the attached cartridge (EPC-
74SMAD, J.C.Penney model 688-2217) is 1.75g.)
As the stylus-pressure ring moves in step with the
balance weight, proper stylus pressure can be
selected by directly reading the graduated ring.
Note:
Set
the
stylus
pressure
to
the
maximum
recom-
mended
value
for
your
cartridge
in
cases
where
the
record
has
an
extremely
high
recording
level,
or
where
the
unit
is
operated
in
a
room
at
low
tempera-
ture,
or
in
places
in
which
the
unit
is
subjected
to
vibrations.
(For
this
unit
the
stylus
pressure
should
be
adjusted
to
2.0g
for
optimum
performance.)
@ Installation of dust cover (See Fig. 8.)
Place the dust cover into position from directly above,
holding it at both sides. For detaching the dust cover, be
certain first to raise it as illustrated before removal.
Note:
Opening or closing of the dust cover during play should
be avoided. This may not only cause undesired
vibrations, but also result in skipping of the stylus.
lf you must open the dust cover during play, do so as
gently as possible.
@ Placement
@) Place the unit in a stable and horizontal position,
where there is little or no vibration.
@) Locate the unit as far away from the speakers as
possible and isolate the unit from sound radiation
(2) Connect the output terminals (See Fig. 9.)
Output terminals
L (White)
R (Red)
GND (Spade lug)
Amplifier or Receiver
Channel
WG Channe!
Note:
Be
sure
to
connect
the
ground
terminal
firmly
to
the
amplifier
or
receiver.
If
this
connection
is
not
made
or
is
loose,
a
power
source
““HUM?’’
will
result.
@ Adjustment of anti-skating
Set the bias knob to the same value as the stylus
pressure. (See Fig. 7.)
from them.
@) Do not place the unit where it is exposed to direct
sun, dust, moisture or heat.
@) Keep it in a well ventilated place.
@ Connections
@ Connect the AC power plug.
Connect the AC power plug to an AC wall socket or to
an
AC
outlet
on
the
back
of
a
receiver
with
a
current
of
120 Volts.