MCS B 35 CEG - User Manual

• T

  Theresa SalazarAug 11, 2025

  Why won't my MCS B 35 CEG start?

  

  Same questionReply

  • L

    Lauren JacksonAug 11, 2025

    Your MCS Heater might not start due to several reasons. First, make sure the generator isn't blocked by trying to reset it. Check that the starter switch is in the “ON” position. Ensure the power supply cable is correctly inserted into the mains socket. Also, verify that the room thermostat is set higher than the current room temperature. If these steps don't work, there may be an interruption in the power supply cable or a blocked control card.

    

    Reply
• S

  Shelia WardAug 25, 2025

  What to do if the motor starts but the flame is not triggered in my MCS B 35 CEG?

  

  Same questionReply

  • T

    tammyhillAug 26, 2025

    If the motor in your MCS Heater starts but the flame doesn't ignite, the possible causes are: * Lack of fuel: Refill the fuel and reset the generator. * Incorrect pump pressure: Adjust the compressor pressure. * Foreign substances in the tank: Empty the tank and refill it with clean fuel.

    

    Reply

MCS B 35 CEG Specifications

Print Specification

General

Dimensions	255 x 300 x 460 mm
Weight	6.7 kg
Voltage	230 V
Frequency	50 Hz
Protection class	IP20
Thermostat	Yes
Overheat protection	Yes
Heating power	3500 W
Power consumption	3500 W
Power	3500 W

Related product manuals

MCS MASTER Series

47 pages

MCS MASTER XL 91

129 pages

MCS Master XL 6

19 pages

MCS BV 170E

104 pages