PowerBook G3 (2000) 13
Installation Checklist
In addition to the new hard drive, the following items should also be
found in the PowerBook hard drive upgrade kit:
- (1) Disposable Grounding Wrist Strap
- (1) MCE Standard/Phillips Combo Screwdriver
- (1) Torx T8 Screwdriver
Installation Procedure
Caution: Electro-Static Discharge (ESD) can easily damage
electronic components. Before proceeding, ensure that you are
discharged of static electricity by touching a grounded metal ob-
ject and by properly securing the provided Disposable Ground-
ing Wrist Strap.
Step 1: Place your PowerBook on a hard, at surface.
Step 2: If your PowerBook is on, turn it off. If the unit appears to be
off, make sure that it is not in Sleep mode.
Step 3: Adjust the PowerBook’s display so that it is tilted back as far as
it will go.
Step 4: Completely unplug all cables from the PowerBook and remove
any batteries, media bay devices, and PC Card modules from it.
Step 5: If the keyboard is locked in
place, unlock it by turning the key-
board lock screw counter-clockwise
with a tiny at head screwdriver.
Note that this keyboard locking
screw is captured and should not be
removed from its slot.
!
To Next Page
Loading...
General