PowerBook G3 (2000) 14
Step 6: Push the keyboard release tabs
towards the front of the PowerBook and
gently lift so that the keyboard pops up
from that end. By holding the top cor-
ners of the keyboard and pulling them up
and out, disengage the tabs on the bottom
of the keyboard which secure it to the inside
of the palm rest .
Step 7: Carefully rotate the key-
board so that it lays face down on
the PowerBook’s palm rest, being
careful not to rip the ribbon cable
attaching the keyboard to the
logic board. Carefully disconnect
the keyboard ribbon cable from
the logic board.
Step 8: Remove the heat shield
by removing its two screws and
pulling it up and out. Make sure
it is not too hot before handling.
Step 9: Remove the screw
that secures the processor heat
spreader in place.
Step 10: Remove the processor
card from its logic board con-
nector by pulling up on the its
pull tab, which is the shorter of
the two translucent tabs located to
the left of the hard drive.
To Next Page
Loading...
General