PowerBook G4 (FireWire 800) 15-inch 23
Step 5: Remove the four screws from the battery door and then remove
the battery door and lay it aside.
Step 6: Remove the two screws
inside the memory bay.
Step 7: Remove the two
screws inside the battery bay.
Step 8: Remove the four
screws along the back edge of
the computer.
Step 9: Remove the three screws on each side of the computer starting
with the screws closest to the back of he computer and working your way
forward. Note: Be sure to replace these screws in this same order when
closing the computer.
Step 10: Remove the two top
screws on the back of the com-
puter.
Step 11: Open the display
and remove the two hex
screws on the top rear cor-
ners, just above the comput-
er's speaker grills using either
a hex wrench or Torx 6 screw-
driver.
To Next Page
Loading...
General