MCZ MAESTRO - Settings Menu: System Functions; Beep, Sleep, and Feed Screw Control; Air Recipe Adjustment

5757
Technical Dept. - All rights reserved - Reproduction is prohibited
4-OPERATION
EN
57
EN
Technical Dept. - All rights reserved - Reproduction is prohibited
4-OPERATION
BEEP ON / OFF
It enables and disables the beeps
1. Press key 1 ( ) to access the settings menu
2. Press key 4 (+) / 5 (-) to select the BEEP ON / OFF function
3. Press key 6 ( ) to conrm the BEEP ON / OFF function
4. Press key 4 (+) / 5 (-) to select ON or OFF
5. Press key 6 ( ) to conrm
SLEEP
It enables you to quickly set the time when the product must switch o. This function is only available with manual and automatic mode
(DYNAMIC).
FEED SCREW ON
This function is useful to avoid alarm A01 caused by ignition failure due to an empty pellet tank, and can be activated with the stove o.
Once the pellet tank has been lled, enable the “START FEED SCREW” function. The loading system (feed screw) will ll up with pellets
in order to prevent the failed stove ignition alarm from triggering. As soon as the rst pellets fall into the brazier, disable the function.
1. Press key 1 ( ) to access the settings menu
2. Press key 4 (+) / 5 (-) to select the START FEED SCREW function
3. Press key 6 ( ) to conrm the START FEED SCREW function
4. Press key 4 (+) / 5 (-) to select the function (ON/OFF)
5. Press key 6 ( ) to conrm
AIR RECIPE
This enables you to view and edit the air recipe settings. To access this function, you must enter password 1234.
This function enables you to adjust combustion air if the ame is too high or too low.
The available values are from -2 to +2.
1. Press key 1 ( ) to access the settings menu
2. Press key 4 (+) / 5 (-) to select the AIR RECIPE function
3. Press key 6 ( ) to conrm the AIR RECIPE function
4. Press key 4 (+) / 5 (-) to enter the rst digit of the password
5. Press key 9 ( )/10 ( ) to select the next eld
6. Press key 4 (+) / 5 (-) to enter the second digit of the password
7. Repeat the above operation for the missing digits.
8. Press key 6 ( ) to conrm
To edit the AIR recipe, select one of the values available by pressing keys 4 (+) / 5 (-) and pressing key 6 ( ) to conrm.
The available values are:
-- 2 = - 10%
- 1 = - 5%
0 = (default value)
1 = + 5%
2 = + 10%
This function is used to adjust combustion air if the ame is insuciently or excessively oxygenated.
Attention! All the adjustments must be performed solely by authorised and qualied personnel. Errors
or incorrect settings may cause hazardous situations and/or incorrect product operation. Any liability for
improper use of the product is entirely borne by the user and relieves the Manufacturer from any civil and
criminal liability.