MCZ MAESTRO - Settings Menu: Maintenance and Info; Cleaning, Frequency, and Anti-Freeze; Software Version Information

5959
Technical Dept. - All rights reserved - Reproduction is prohibited
4-OPERATION
EN
59
EN
Technical Dept. - All rights reserved - Reproduction is prohibited
4-OPERATION
BRAZIER CLEANING
This is used to start the cleaning cycle. This function is only for “MATIC” products with an automatic brazier cleaning system.
1. Press key 1 ( ) to access the settings menu
2. Press key 4 (+) / 5 (-) to select the BRAZIER CLEANING function
3. Press key 6 ( ) to conrm the BRAZIER CLEANING function
4. Press key 4 (+) / 5 (-) and scroll to select the function
5. Press key 6 ( ) to conrm
ADJ. FREQUENCY
This is used to raise or lower the temperature detection frequency. If the frequency is low, the remote control batteries will be used up
quicker.
1. Press key 1 ( ) to access the settings menu
2. Press key 4(+) / 5 (-) to select the ADJ. FREQUENCY function
3. Press key 6 ( ) to conrm the ADJ. FREQUENCY function
4. Press key 4 (+) / 5 (-) and scroll to select the function
5. Press key 6 ( ) to conrm
SOFTWARE VERSION
Display of the product’s software versions. Through this function, it is possible to know all the stove’s information.
1. Press key 1 ( ) to access the settings menu
2. Press key 4 (+) / 5 (-) to select the SOFTWARE VERSION function
3. Press key 6 ( ) to conrm the SOFTWARE VERSION function
4. Press key 1 ( ) to go back to the main menu
ANTIFREEZE ICE
When the water temperature drops below 5 °C, with ANTI-FREEZE (ICE) function enabled (ON), the circulator switches on. The remote
control is set with the ANTI-FREEZE (ICE) function on
1. Press key 1 () to access the settings menu
2. Press key 4 (+) / 5 (-) to select the ANTI-FREEZE (ICE) function
3. Press key 6 () to conrm the ANTI-FREEZE (ICE) function
4. Press key 4 (+) / 5 (-) and scroll to select the function
5. Press key 6 () to conrm