1. Clean the treatment window with
a non-alcohol based wet wipe or
soft tissue. This is done in order to
remove any debris or dust from
the treatment window.
2. Connect the power cord into the
power supply port found on the
control panel of the mē.
3. Connect the power cord to an
AC outlet.
4. Press the power button to turn
the device on. All 3 energy level
indicators will light up blue and
start blinking.
Using your mē for the rst time
Setting up your mē
1
2
3
4
5
6
5. Press the elōs button once to
select the LOW energy level.
When the energy indicator
lights up steady blue, the mē is
ready for use.
6. To increase the setting to
MEDIUM or HIGH, press the
elōs button until the indicator
displays the desired level.
Note: When moving from HIGH to LOW, the device will
reset. The energy indicator lights will cycle momentarily
before the LOW energy indicator light appears a steady
blue. Proceed treating on LOW only after the the LOW
indicator light is steady.
To Next Page
Loading...
