19
EN
travel with
The me system is designed with universal voltage. That means that you can use
the system all over the world. You will need to use an adaptor for the plug, since
electrical wall outlets vary by country. Make sure that me system does not get
wet while traveling and do not use it in a wet environment. A travel bag may be
purchased separately at www.mepower.com.
troubleshooting
Indicator What does it mean How to react
Device
No lights are on Power cable is not connected Connect power cable
All energy setting
buttons are blinking
(High-Medium-Low)
No energy level was
selected
Select an level. The applicator fan will
start blowing indicating that the cartridge
is active
activation button
on the applicator is
blinking
energy level was selected
but activation button was
not pressed yet
Press the activation button. The
applicator fan will start blowing indicating
that the cartridge is active
Error light is on Need to reset the system Reset the system by turning it off and on
again. If problem persists, disconnect
power cord and wait until all lights are off
(several seconds). Then reconnect the
power cord and turn on system. If error light
is still on, try moving to a cooler area with a
room temperature of less than 30ºC/ 86ºF
and restart the system
No ashes are coming
out
1. RF chrome skin contact
bars not in contact with the
skin in treatment area
2. activation button is not
pressed or energy level
was not selected
In order for the system to ash pulses, make
sure all 3 conditions are met: level
selected , activation button is pressed,
RF chrome skin contact bars are in contact
with skin
To Next Page
Loading...
