800-797-4632 . mecoutdoors.com
3
any variations in weights. Adhering to loads recommended by the powder manufacturer is a
must. Always wear safety glasses!
On your machine and in this operator’s manual safety labels and statements contain
the words DANGER for the most serious hazards and CAUTION to call attention to safety
messages.
SAFETY INFORMATION CONTINUED
MEC AUTO-MATE ASSEMBLY MANUAL
DANGER
!
CAUTION
!
ELECTRICAL:
1. To avoid electrical shock, which can cause severe personal injury or death do not cut or
remove the round grounding prong from the plug. The machine must be grounded at all
times. Do not remove warning tag from the power cord, use a two-prong adapter or use an
extension cord.
Electrical Grounding Instructions - This machine is equipped with a three-prong (grounding)
plug for protection against possible shock hazards. If you encounter a two prong receptable,
contact a qualied electrician and have the two-prong wall receptacle replaced with a properly
grounded three-prong wall receptacle in accordance with the National Electrical Code.
Machine is designed to perate on a separate 110 to 120 volt. 15 amp. 60 cycle line.
2. Avoid contact with energized circuits.
3. Do not depend on motor control devices (switches, etc. ) to prevent unexpected motor
starting. Always disconnect power source before working on or adjusting machine.
4. Protect the power cable: don’t let it touch sharp objects, hot surfaces, oil, grease, or
chemicals. Do not kink the power cable.
5. DO NOT use this equipment in an area where explosive vapors are present.
6. Disconnect power supply before servicing or making any adjustments.
MECHANICAL:
1. Keep hands and ngers CLEAR of all moving parts.
2. Your machine is quite heavy. Be sure to use your MEC Auto-Mate on a structurally sound
table or bench.
DANGER
!
CAUTION
!
DANGER
!
To Next Page
Loading...
Need help?
General
