15
www. mechmaxx.com
OPERATION
A leaking fuel line no matter how small can be the source
of a fire or explosion when starting or operating the
engine.
Inspect the entire fuel system. Look for: Signs of leaks or
deterioration, chafed or spongy fuel hose, loose connec-
tions, loose or missing fuel hose clamps, damaged gaso-
line tank, or defective gasoline shut-off valve.
If grinder is in an enclosed area and you smell gas, DO NOT
start engine! DO NOT light a match. DO NOT flip on an
electrical switch.
Exit area immediately leaving doors open and call fire
department.
After you have completed the pre-start checking list and
procedures, you are ready to start the grinder.
The following directions details how to start the engine of
your grinder.
Handle is capable of folding when not in use.
Never attempt to use the grinder without
proper protective equipment, particularly
eye protection and a full-face shield.
Stay in the OPERATOR POSITION (Behind
the machine) while actuating controls.
Never leave grinder unattended.
WARNING: Flying Debris Hazard
GRINDING THE STUMP
LOCKING HANDLE BAR
STARTING THE GRINDER
Use approved protective clothing and approved protective
equipment when using the machine.
• Always wear safety glasses with side shields and a
full-face shield.
• The use of ear plugs or other hearing protection device
is also recommended for persons working within 15-20
feet (5-6.5m) of the running grinder for longer than a
few minutes. Hearing can be damaged from prolonged,
close- range exposure to the type of noise produced by
this grinder.
• Wear long pants to protect legs from sparks, hot engine
and flying debris.
• Never wear jewelry or loose-fitting clothing when start-
ing or operating the grinder or any mechanical device.
Loose or dangling apparel, jewelry or hair can become
entangled in moving parts.
• Neither the machine as a whole nor its internal compo-
nents are intended for use in potential explosive atmo-
spheres.
• Pull the starter grip lightly until you feel resistance,
then pull briskly. Return the starter grip gently. If the
choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as
the engine warms up.
• Press down on handle bar to lift cutter wheel off the
ground.
• Grip throttle control lever and handle bar together in
right hand. Centrifugal clutch will engage and cutter
wheel will begin to rotate.
PERSONAL PROTECTION
Trim Stump with
Saw
Cut or trim the stump preferably
to ground level using a power
saw.
Clear Area
Dig away the earth and remove
any stones near the tree stump or
roots that may interfere with your
work.
Working During
Daylight Hours
Only use the machine in daylight
or in well-lit conditions. Never
operate the grinder after dark.
To Next Page
Loading...