16
www. mechmaxx.com
OPERATION
Keep hands and feet away. Contact with wheel rotating
teeth will cause serious personal injury.
• When grinding larger stumps, chips may begin to build
up under the wheel.
• Release brake and pull machine towards you so that the
"chip pile" is directly under the cutting wheel.
• Drop cutter wheel down on "Chip pile", material will be
discharged from machine area.
Stones, chips, and debris can cause serious injury or
property damage.
Debris can fly 75 ft (25m) in any direction out of the
chute. They can bounce off any fixed objects as well and
hit operator, bystanders or breakable objects.
• Set/engage the brake.
• Pivot the grinder toward the side of the stump, with a
fairly light touch feed straight into the stump. As soon
as you feed in, start to swing to the side until you feel
the wheel drop off the edge of the stump.
Change direction and swing back the other way until you
feel it reach the other edge of the stump. As you swing to
the side listen to the engine. Provide enough feed to give
it a moderate load. If you hear any belt or clutch squealing
you are pushing to hard. If you can not swing it to the side,
raise the grinder up.
You can cut roots off by plunging straight through them.
Stones, chips, and debris can cause serious injury or
property damage.
Debris can fly 75 ft (25m) in any direction out of the
chute. They can bounce off any fixed objects as well and
hit operator, bystanders or breakable objects.
• On these large stumps, DO NOT allow grinder wheels to
drop into stump hole. If a hole is in the way of your
progress, fill it with chips or change position.
• When finished, stop the engine.
• Pull machine away from stump, and rack chips away-
from stump.
• Before removing gas cap, turn engine off and allow to
cool for at least two minutes.
Note: A running or hot engine can ignite fuel.
• Remove grinder gasoline cap.
• Add gasoline through the fill opening
- Use only an portable gasoline container to transfer the
gasoline to the grinder's tank.
- Be aware of safety warning and instructions below for
avoiding static electric caused fires.
- Do not overfill.
A static electric spark can explosively ignite gasoline
vapor, resulting in a flash fire that could cause serious
injury or death. See "Special Safety Information on Static
Electricity" at end of this manual.
WARNING: Rotating cutter wheel
WARNING:Static electric spark hazard
WARNING: Flying Debris Hazard
Stop engine and set brake before leaving
operator's position. KEEP BRAKE
ENGAGED except when changing loca-
tions.
REFUELING
Cutter wheel
Chip pile
To Next Page
Loading...