MED-EL OPUS 2 User Manual (English)

Other manuals for MED-EL OPUS 2

User Manual56 pages

Equipment Guide33 pages

Quick Guide8 pages

How To Fit3 pages

Questions and Answers:

J
jessemorrisAug 1, 2025
What to do if MED-EL Hearing Aid OPUS 2 does not respond to FineTuner commands?
- J
  Jessica FoleyAug 2, 2025
  If your MED-EL Hearing Aid OPUS 2 isn't responding to FineTuner commands, here's what you can check: * Make sure the OPUS 2 is within the FineTuner's transmission range (approximately 0.8 meters); move closer if needed. * Deactivate the Automatic Keyboard Lock if it's enabled. * Try moving to a different location to avoid potential interference. * If the devices aren't synchronized, synchronize the OPUS 2 and FineTuner. * Replace the FineTuner battery if it's low. If these steps don't resolve the issue, it may be necessary to contact your audiologist, as commands or the LED in OPUS 2 might be disabled.
T
Taylor PhillipsAug 7, 2025
Why my MED-EL Hearing Aid OPUS 2 is not responding to FineTuner commands?
- M
  Michael VasquezAug 7, 2025
  If your MED-EL Hearing Aid OPUS 2 isn't responding to FineTuner commands, several factors could be at play. First, ensure the FineTuner is within operational range of the OPUS 2. Move it closer. Also, check if the FineTuner keyboard lock is active; if so, unlock it. Interference from other electronic devices can also be a factor; try moving to a different location. Ensure that the OPUS 2 and FineTuner are synchronized. If the FineTuner battery is low, replace it. Finally, it's possible your audiologist disabled the command during fitting. In that case, contact your clinic, CI center, or MED-EL to enable the command.
S
santostamaraAug 13, 2025
What to do if the red indicator light on MED-EL OPUS 2 Hearing Aid shows warning patterns?
- M
  Michelle WaltonAug 13, 2025
  If the red indicator light on your MED-EL Hearing Aid is showing warning patterns, it could mean a couple of things. First, check your batteries; they might be empty. If so, switch the processor off, change the batteries, and then switch the processor back on. Another reason could be that you've reached the maximum or minimum value of the volume or audio sensitivity range. If this is the case, simply stop pushing the buttons on the FineTuner.