22
6. HOW TO RELOAD A NEW PROBE COVER
Place a probe cover onto the
storage case hole with paper
side upwards (Pic.2).
Completely push the probe into
the probe cover holder hole
(Pic.3).
Take the unit, vertically
penetrate the probe into the
centre part of the probe cover
(Pic.4).
Pic. 2 Pic. 3
Pic. 4
Pic. 5
After feeling a slight click, take
out the probe with cover
attached tightly (Pic.5).
Pic. 6
NOTE
• In order to avoid cross-contamination, please reload a new
probe cover for each patient.
• Please check if the probe cover is fitted on firmly before use (fig.
6). If the probe cover is broken, discard the probe cover and
reload a new one immediately.
To Next Page
Loading...