Preparing to express
Place the membrane into the valve
base from above. Make sure it fits
securely around the rim by pressing
down with your fingers to ensure
it seals completely.
Press the Motor unit to the end of the
membrane until it clicks into place.
How to charge. If battery indicator flashes, battery requires charging. To charge,
insert power cable into connection point on the back of motor unit, plug into a power
outlet and switch on at the outlet. Charge until battery indicator full and stop blinking.
Switch power off at outlet. Disconnect both pump and power outlet before use.
The built in rechargeable battery lasts for 3 hours allowing on the go pumping.
7
To Next Page
Loading...
