What to do if my Medela Solo Breast Pump is not responding?
If your Medela Breast Pump is not responding as expected, press and hold the On/Pause/Off button for two seconds to switch the breast pump off, then restart it. If there is still no change, contact Medela Customer Service.
Why is there low or no suction in my Medela Breast Pump?
If you experience low or no suction with your Medela Breast Pump, ensure that all pump set components are clean and dry and that connections are secure. While pumping, make sure the breast shields form a complete seal around the breast. If suction does not improve after these steps, contact Medela Customer Service.
How to restart Medela Breast Pump when it is not responding?
If the Medela Breast Pump is not responding as expected, press and hold the On/Pause/Off button for two seconds to turn the breast pump off, then restart it.
Why is there low suction on my Medela Solo?
If your Medela Breast Pump has low or no suction, ensure that all pump set components are clean, dry, and securely connected. While pumping, verify that the breast shield forms a complete seal around the breast. If the suction does not improve after these steps, contact Medela Customer Service.
What to do if Medela Solo Breast Pump status light is flashing red?
If the status light on your Medela Breast Pump is flashing rapidly in red when you try to pump or charge it, this could be because the battery temperature is too high. Allow the pump unit to cool down, then resume charging/pumping. If the status light continues to flash rapidly in red, it indicates a device fault, and you should contact Medela Customer Service.
What to do if the exterior of my Medela Breast Pump gets wet?
If the pump unit’s exterior got wet, unplug the pump unit from the power source and turn it off. Dry off the exterior of the pump unit.
What to do if my Medela Breast Pump has been submerged in water?
If the pump unit has been submerged in water, unplug it from the power source, turn it off, and then contact Medela Customer Service.
What to do if the status light is flashing red on my Medela Breast Pump?
If the status light on your Medela Breast Pump is flashing rapidly in red, it could be due to the battery temperature being too high. Allow the pump unit to cool down before resuming charging or pumping. If the issue persists, it indicates a device fault, and you should contact Medela Customer Service.
What to do if my Medela Solo Breast Pump unit gets wet?
If the pump unit’s exterior got wet: * Unplug the pump unit from the power source and turn it off. * Dry off the exterior of the pump unit.
What happens if my Medela Solo is submerged in water?
If the pump unit has been submerged in water, unplug the pump unit from the power source and turn it off. Then, contact Medela Customer Service.
Lists all the components included with the Solo breast pump, with images.
Outlines essential steps to clean the breast pump parts before the first use.
Provides instructions on how to charge the breast pump's battery.
Guides users on how to measure their nipple to select the correct breast shield size.
Details assembling the pump set and preparing for pumping.
Provides step-by-step instructions for expressing breast milk using the pump.
Describes the function of each button and the meaning of the status light indicators.
Details washing, sanitizing, and drying procedures for pump parts.
Covers battery maintenance, charging, and lifecycle preservation for optimal use.
Provides guidelines for storing freshly expressed breast milk at different temperatures.
Provides solutions for common issues encountered with the breast pump.
General| Type | Electronic |
|---|---|
| Diameter | 21 mm |
| Bra clips | 2 pc(s) |
| Product color | Transparent, Yellow |
| Skin-friendly | Yes |
| Built-in display | No |
| Number of stimulation levels | 6 |
| Power supply type | Battery |
Weight and Dimensions| Capacity | 150 ml |
|---|
To Next Page