Symphony PLUS
®
provides two programs to help Initiate.Build.Maintain
™
milk supply
Assembly for Double & Single Pumping
2
Carefully push the white
membrane onto the yellow valve
head until it engages.
1
Wash hands thoroughly with
soap and water before touching
breast pump set and breasts
and avoid touching the inside of
containers or lids.
CAUTION
3
Push the breast shield onto the
connector.
4
Push the yellow valve head
and white membrane onto the
connector.
• Position valve head sideways.
Screw the bottle into the connector.
5
8
Insert the tubing adapter into the
opening in the membrane cap.
7
Place the protective membrane
onto a flat surface and carefully
push the membrane cap down
until it engages.
6
Insert the tubing into the
corresponding opening in the
connector.
9
Open the lid of the breast
pump.
• Press the oval button on the
top of the Symphony and lift
the handle.
Position the membrane cap
firmly on the breast pump
membrane to form a seal.
10
Close the lid.
12
Center the tubing connector in
the recess in the pump housing.
• Make sure that the
membrane cap engages and
lies flush to the surface.
11
NOTE
• For step 12:
Always close the lid when
pumping. The lid keeps the
membrane cap pushed
down to prevent a loss of
vacuum that could occur if the
membrane cap came off.
Helpful Resources to Get Started Using Symphony PLUS:
Scan the QR code for helpful
videos on how to set up, use, and
clean the Symphony Breast Pump.
To Next Page
Need help?
General
