EFFICIENCY
Symphony
®
Breastpump
Quick Instructions
Assembling the Pump Set
It is very important that these components
are cleaned thoroughly after every use.
Use of the Breastpump
The Stimulation Phase
Check that the cable on the back of
the breastpump is connected behind
the cover with an arrow on it. Start the
breastpump with the On/Off button.
Pumping always starts at the same
vacuum level. This is indicated by three
drops on the display.
The Expression Phase
Switch between the Stimulation and
Expression Phase in two ways:
1
automatically, the breastpump
switches after two minutes of the
Stimulation Phase or
2
manually, by pressing the right-
hand button (
button ) when you
see milk ow.
When switching from the Stimulation
Phase to the Expression Phase the
vacuum level increases gradually
within 4 seconds by adding three bars
to the last stimulation setting.
Easy to switch between Stimulation
and Expression. When the breast-
pump automatically switches to the
Expression Phase you can press the
right-hand button to return to the
Stimulation Phase. If milk has not
begun to ow after two consecutive
Stimulation Phases, take a break and
try again after 15 – 30 minutes. Try
breast massage (ask your lactation
consultant or doctor) and then try to
pump again using the Expression
Phase.
Carefully push the
membrane onto the valve
head until it engages.
1
Push the breastshield
onto the connector.
2
Push the valve head and
membrane onto the
connector ➞ position
valve head laterally.
3
Screw the bottle onto the
connector.
4
Insert the tubing into the
corresponding opening in
the connector.
5
Insert the second end of the
tubing into the opening in the
membrane cap.
7
Press the membrane cap (during
double pumping both membrane caps)
properly onto the breastpump
diaphragms.
8
1
2
3
Remembers the last vacuum
setting in the Stimulation Phase.
A memory function remembers the last
vacuum level in the Stimulation Phase.
Adjust the vacuum during pumping by
turning the button clockwise (increase)
or counterclockwise (decrease).
Note: These short instructions are not a replacement
for standard instructions. For cleaning of the pump set
see standard instructions, REF 200.7068
Place the protective membrane
onto a at surface and carefully push
the membrane cap down until it
engages.
6
To Next Page
Need help?
General
