USB Memory
23
Notes:
1. It will take a few minutes to finish loading a user voice, please wait
patiently.
2. If the LCD displays “Unsupported file”, it indicates this format does
not meet requirement, please change it to the WAV format as
specified above.
3. User voices cannot be edited or deleted. If the capacity is full, you
can reset voice settings to factory default and erase all user voices.
(Please refer to Factory Reset for details.) After voice reset, you can
load voice files to the module as needed.
4. After voice reset, all user voices on the module are deleted. The user
voices in user kits will be replaced by MUTE voices.
5. The loaded voices will be placed between the preset voices and the
Hihat Combination voices, starting from no.651 with a voice number
of “Uxx”.
Format USB Memory
After formatting, all data saved on USB flash drive will be erased.
Please backup any important data before formatting.
1. Press the [SONG] button, then press the [MENU] button to enter
USB menu.
2. Press the [∧]/[∨] buttons to select “Format USB memory”, then
press [F3 (ENTER)]. The LCD will prompt “Format the USB memory!
Exit/Enter?”
3. Press [F3 (ENTER)] to confirm formatting, and the LCD will display
“Waiting!”.
Or press the [EXIT] button to exit and return to the previous menu.
SONG
F3
EXIT
C
M
Y
CM
MY
CY
CMY
K
AW_DD638DX_manual_G01_180529.pdf 23 18/5/30 11:05
To Next Page
Loading...
Need help?
General
