SAFETY INSTRUCTIONS
5
Setting up and electrical connection
• Connect the microwave only with an appropriate 230V~50Hz safety plug
which has at least a 16 Amp fuse. To prevent tripping, please avoid using
an extension cable.
• Ensure that the power cable is undamaged and does not run underneath
the appliance or over any hot surfaces.
• The microwave should be set up on a level, stable surface, which is able
to carry the weight of the appliance as well as the food which is to be
prepared within it. Only set up the microwave in a safe, dry environment.
• Please pay attention to the minimum safe
distances and under no circumstances cover the
ventilation slots. Do not place any objects on the
microwave as these may become hot during use.
To ensure adequate ventilation a minimum safe
clearance distance of 30cm and 10cm on both
sides must be observed. The openings in the
appliance should not be covered or blocked.
• Protect the device from water droplets or spray. If the appliance does
become wet then pull out the plug immediately.
Warning!
During use the touchable surfaces may become very hot!
Attention!
Hot surface!
10824 manual UK.book Seite 5 Freitag, 11. November 2005 3:38 15
To Next Page
Loading...
Need help?
General