This section contains information about setting up your instrument and preparing to play. Please
go through this section carefully before turning the power on.
You can power the unit either by batteries or by power
adaptor. Follow the instructions described below.
Using Batteries
6 pieces of C size (SUM-2 or R-14) or equivalent alkaline
batteries must first be installed into the battery
compartment.
1. Open the battery compartment cover located on the
bottom cabinet of the unit.
2. Insert the batteries, carefully follow the polarity
markings on the cabinet.
3. Close the compartment cover, making sure that it locks
firmly in place.
Caution:
Do not mix old and new batteries.
Always use same types of batteries.
Always remove the batteries from the unit when it is not
being used for an extended period of time.
Using Power Adapter
1. First, please make sure that POWER ON/OFF switch
of the instrument is set to OFF.
2. Connect the AC adaptor to the power supply jack.
3. Plug the AC adaptor into an AC outlet. And when
turning the power OFF, simply reverse the procedure
please. This will automatically cut off the battery power
supply.
4. Turn the power ON.
Note:
When the keyboard is not in use or in the time of
thunderstorm, please disconnect the power for safety
purpose.
A prompt voice sounds every two minutes if there is no
operation.
Setup
Power Supply
6
To Next Page
Loading...
Need help?
General
