Medisafe SI DIGITAL - Important Information

5
Section 1-2 - Important Information User Manual
Ref: UM SI Digital II 5 07/08 Rev.A
Electrical
The power cord and connector supplied with
this machine are wired according to the follow-
ing colour code:
240V 110V
Live BROWN BLACK
Neutral BLUE WHITE
Earth GREEN/YELLOW
If the supplied connector is removed, be sure
to observe the colour code when reconnecting
to an appropriate plug or fused spur.
For details of fuse replacement refer to
Section 1-8: Routine Checks.
Important Note:
To prevent re or shock hazard, do not
expose the unit to rain or moisture.
Dangerously high voltages are present
inside the unit. Do not open the cabinet.
Refer servicing and repair to qualied
personnel only.
Installation and Maintenance:
Observe the Routine Checks (Section 1-8),
Installation Instructions (Section 2-5) and the
Servicing requirements (Section 2-8) outlined
within this manual.
Intended Purpose:
The product is designed to be used in conjunc-
tion with pH neutral aqueous cleaning uids.
It should not be used ammable materials or
gases and should not be used for any purpose
other than that dened by the manufacturer
as the Intended Purpose (Section 1-3).
Warning:
If the equipment is used in a manner not
specied by the manufacturer, the protection
provided by the equipment may be impaired.
Chemicals:
This product contains a heating device and
the use of substances or chemicals other than
those specied may be hazardous. Never use
toxic, corrosive, or ammable liquids.
Read the Chemical Safety Information in
Section 2-3 of this manual before use.
Note:
Using non-approved chemicals may cause
damage to the machine and could void
both your warranty and your guarantee of
performance.
Heat:
The temperature within the unit can reach
65
o
C or more during and after operation. Take
care when removing items on completion of a
cycle and allow good time for the items to cool
to a safe temperature before handling.
Decontamination:
This product MUST be decontaminated in
accordance with local regulations before
transporting. In the event that the product
must be returned to the supplier, it is vital that
the Decontamination Certicate (Section 2-9)
of this manual is completed and returned with
the product.
Manufacturer Information:
Medisafe UK Ltd
The Snap Factory
Twyford Road
Bishop’s Stortford
Hertfordshire
CM23 3LJ
England
Telephone: +44 (0) 1279 461641
Fax: +44 (0) 1279 461643
E-mail: info@medisafe.uk.com
Web: www.medisafe.uk.com