Medisafe SI DIGITAL - Operating a Wash Cycle

Before Operating a Wash Cycle
• Ensure that a new
drain lter is tted
into the drain at
the bottom of the
wash tank.
• Ensure that a
correctly loaded
basket is in the
wash tank and that the basket hose is
connected to the
port on the bottom
of the wash tank
(refer to page 8).
• Ensure that the
drain tap is in
the fully closed
Position.
Operating a Wash Cycle
1. Fill the wash tank to the full mark with water
at 40
O
C.
2. Add 3E-Zyme detergent in the ratio of
7ml/3E-Zyme per litre/water.
3. Connect the unit to the mains supply and
switch on.
4. Check that the LED display on the front
panel is indicating ‘ -- ‘ and press the ‘On’
key once.
The LED display will now indicate the
default time of the intended wash cycle
and the yellow ‘Heater’ enable led will be
illuminated.
5. Close lid and press the ‘START’ key once to
commence the cycle.
The green ‘Process’ led will be lit, a light
will ash on the LED display, and the time
remaining until the end of the wash cycle
will be indicated.
9
Section 1-6 - Operating a Wash Cycle User Manual
Ref: UM SI Digital OI 9 07/08 Rev.A
(the countdown process will continue even
if the LED display is ashing or the display
has been changed to Temperature).
At the End of the Wash Cycle
Once the cycle has completed the LED display
will return to the default cycle time of 15
minutes (see page 10).
The lid may now be opened and the contents
of the wash tank removed.
Pausing a Wash Cycle
If it is necessary to pause a cycle whilst in
progress, press the ‘START’ key once.
Press the ‘START’ key again to resume the
cycle.
Changing the Wash Cycle Time
The wash cycle time may be changed before or
during a cycle in the following way:
• To increase the cycle time, press and hold
the ‘Plus’ key until the required time is
displayed.
• To decrease the cycle time, press and hold
the ‘Minus’ key until the required time is
displayed.
Note:
Changing the time in this way affects ONLY
the current wash cycle. To amend the default
time, refer to page 8.
Note:
To get the best performance from this cleaner
the rst cycle after lling with fresh water
should be run with no instruments, This is
known as the de-gas cycle and removes
dissolved gasses from the water.