Medit i500 - Proper Training; In Case of Equipment Failure; Hygiene

16
User Manual
17
Intraoral Scanner i500
Before using your i500 system on patients:
»
Handling and replacing the tip.
For clean working conditions and patient safety, ALWAYS wear clean surgical gloves
when:
▪
5.2 Proper Training
5.3 In Case of Equipment Failure
5.4 Hygiene
WARNING
WARNING
WARNING
You should have been trained to use the system, or you should have read and fully
understood this user guide.
You should be familiar with the safe use of the i500 system as detailed in this user guide.
Before use or after changing any settings, the user should check that the live image is
displayed properly in the camera preview window of the program.
▪
▪
▪
Remove the device from the patient’s mouth and discontinue use immediately.
Disconnect the device from the PC and check for errors.
Contact the manufacturer or authorized resellers.
Modifications to the i500 system are prohibited by law as they may compromise the
safety of the user, patient or a third party.
▪
▪
▪
▪
Due to its fragile nature, i500 tips should be handled with care. To prevent damage
to the tip and its internal mirror, be careful to avoid contact with a patient’s teeth or
restorations.
If i500 is dropped on the floor or if the unit is impacted, it must be calibrated before
use. If the instrument is unable to connect to the software, consult the manufacturer or
authorized resellers.
If the equipment fails to operate normally, such as having issues with accuracy, stop
using the product and contact the manufacturer or authorized resellers.
Install and use only approved programs to ensure proper functionality of the i500
system.
▪
▪
▪
▪
5 Safety Guide
If your i500 system is not working properly, or if you suspect that there is a problem with the
equipment: