Medivators DSD-201 - Internal Water Filter Removal and Replacement

£
ΜΕΡΙΝΑΤΟΡΘ΄
4 REPROCESSING SYSTEMS
Shutdown
Use the following process to shutdown the reprocessor at the end of the day.
1. Turn the external air source to OFF (if applicable).
2. Close the incoming water line shutoff valve.
3. Sanitize the reprocessor upper basins and basin lids with an EPA-registered sanitizer,
such as properly diluted Actril® Cold Sterilant. Follow the sanitizer manufacturer’s
recommendations for proper use.
Warning! Avoid possible chemical burns. Always wear personal
® protective equipment (gloves, goggles) when handling
sanitizer.
Caution! Avoid damage to the reprocessor. Do not allow sanitizer to
contact any metal components.
4. Check the detergent reservoirs and alcohol reservoirs for proper level.
5. Refill the alcohol reservoir, if necessary.
6. Clean and refill the detergent reservoir, if necessary.
- Clean the reservoir cap, bracket and detergent reservoir.
- Flush the reservoir thoroughly with hot water.
- Refill the reservoir with detergent.
1
32
MM03-0047
Revision
D