Medivators DSD-201 - Page 142

a
REPROCESSING SYSTEMS
w LEVELING
The reprocessor must be installed on a level surface or be adjusted to level. Adjust the lev-
eling pads after unpacking the reprocessor.
134
1.
OOA
R
ON
Loosen the disinfectant reservoirs.
・ On older models, remove the 2 bolts securing the reservoir.
* On newer models, remove the 2 pins securing the reservoir.
Slide the reservoirs forward far enough to access the rear leveling pads (bolts).
Place a bubble level on the basin surface in position “A”.
Adjust the rear leveling pads until the bubble is centered in the level glass.
Move the bubble level to position “B”.
Adjust the front leveling pads (flathead screws) until the bubble is centered in the level
glass.
7. Verify the reprocessor is level.
Slide the reservoirs back to the original position and secure.
MM03-0047 Revision D