Medivators DSD-201 - Solenoid Valve Cleaning and Seal Replacement

©" REPROCESSING SYSTE
y
142
INTERNAL WATER FILTER-REPLACE
1.
Install the new water filter cartridge.
Warning! Always wear gloves when handling the filter cartridge.
oS
+ Insert the filter cartridge into the housing cap.
+ Turn the filter cartridge clockwise until the tabs locks into the cap.
2. Wipe the filter housing clean with a lint-free cloth.
3. Install the filter housing onto the housing cap.
ON
O
A
PR
* Apply an NSF-approved silicone lubricant to the housing o-ring to aid assembly
and sealing.
・ Tighten the housing into the cap by hand. Do not overtighten.
Reconnect the water inlet line.
Close the bleeder valve on the filter housing.
Turn on the water supply and check for leaks.
Bleed any air from the housing using the bleeder valve.
Perform the Water Line Disinfect procedure as described in the Operator Controls
chapter.
MM03-0047 Revision D