Medivators DSD-201 - Flow Sensor Cleaning Procedure

w PRINTER PAPER-REPLACE
Use the following procedure to replace the printer paper. Only use Medivators supplied
paper.
1. Raise the printer compartment cover on the reprocessor and remove the printer from
the compartment.
Remove the used paper roll.
+ Press the paper feed switch to advance the paper beyond the cutting blade.
* Cut any remaining paper on the roll from the printer.
* Pull the remaining paper toward the paper cutter, through the printer mechanism.
Caution! Avoid damaging the printer mechanism. Never pull paper
from the back of the printer. Always pull forward, towards
the cutting blade.
. Install the new paper roll.
* Unroll several inches of paper from the new roll and trim the leading edge even.
・ Feed the paper through the printer feed slot.
ㆍ Press and hold the paper feed switch until the paper exits the top of the printer.
・ Release the switch after several inches are exposed.
Insert the spindle through the paper roll and position the roll in the slots.
・ Verify the roll turns freely. Paper jams could damage the printer mechanism.
5. Pull the exposed paper through the slot in the printer cover and lower the cover.
6. Replace the printer in the printer compartment. The printer is ready for normal use.
144
MM03-0047 Revision D