Medivators DSD-201 - Disinfectant Reservoir Removal

w PRINTER RIBBON-REPLACE
Replace the ribbon before the printing becomes difficult to read. Use the following proce-
dure to replace the printer ribbon.
1.
Raise the printer compartment cover on the reprocessor and remove the printer from
the compartment.
Unplug the printer power cable.
3. Remove the printer cover.
‧ Press down on grooved corners until the cover rotates upward.
* Lift the printer cover off the printer case.
Replace the cartridge.
* Push down on the ribbon cartridge, marked PUSH.
* Remove the cartridge and discard.
Install the new Medivators approved ribbon cartridge.
* Align the cartridge in the slot and press down until firmly seated.
» If there is paper in the printer, slide the paper between the cartridge and the ink
ribbon before seating the cartridge in place.
・ Turn the small knob clockwise to adjust the ribbon tension.
Caution! Prevent ink stains. Do not allow the ribbon to contact the
printer case. Wipe any ink from the case immediately to
prevent stains.
6. Reinstall the printer cover.
7. Replace the printer in the printer compartment.
8. Turn on the printer. The printer is ready for normal use.
146
MM03-0047 Revision D