Medivators DSD-201 - Reprocessor System Specifications

== MEDIVATORS
Cm REPROCESSING SYSTEMS
Specifications
Chassis Dimensions
(height x width x depth)
46x36x21 inches (117x91x53 cm)
Height with lid open 64 inches (162.5 cm)
Weight (approx.) 400 Ibs. (181 kg)
Power Cord Hospital grade — 8 feet (2.5m)
Altitude <15,000 feet (4,572m)
Humidity 20% to 80%, non-condensing
Temperature 80°F 4 20° (27°C + 10°)
Mains Supply Voltage Fluctuations Not to exceed +10% of the nominal voltage
Installation Over Voltage Category
Il
Classification
I, Ordinary Protection
Electrical Requirements
230 VAC 50/60 Hz, 6 amp, l$
120 VAC 60 Hz, 12 amp, 14
Water Requirements Potable water from building (cold water supply). 35-40psi (2.4 -
2.75bar) at regulator.
Water temperature maximum: 110°F (43°C)
Rinse Water Consumption
Approx. 10 gallons (39 liters) per cycle
Designed for Use Indoor
Environmental Rating Standard
Pollution Degree 2
Mode of Operation Continuous
Degree of Mobility Stationary
Waste Drain
The reprocessors drain is 25 inches (60cm) above the floor.
Because the reprocessor uses a gravity system there must be at
least a 3 inch (25mm) drop from the reprocessor over 36 inches
(30cm) for proper draining.
Capacities
Disinfectant reservoir: 15 liters
Basin: 11 liters.
Alcohol and detergent reservoirs: 800ml] each
Disinfectant Compatibilities
Contact your local distributor for compatible reprocessing
chemicals.
Internal Heater
Ambient temperature to 125°F (52°C)
A-10
MM03-0047 Revision D