Medivators DSD-201 - Page 20

δα
“© REPROCESSING SYSTEMS
\
Installation Verification
To be sure that the system is ready to operate, perform a trial run with water as outlined below.
Use scope hook-up to simulate an endoscope.
might blow the 8-amp slow blow fuse. Operating the
230VAC reprocessor without a hook-up fitting might blow
the 4-amp slow blow fuse.
1 Caution! Operating the 120VAC reprocessor without a hook-up fitting
1. Load the lower reservoir with water. Use the procedure described in the Operator Con-
trols Chapter for loading disinfectant.
2. Fill the alcohol and detergent reservoirs, then prime the tubing.
・ Enter the Custom Programs menu.
* Set the alcohol and detergent inject time to 15 seconds.
3. Close the lid, then press the START button.
4. Check the flow through the tubing during the disinfect, air, and rinse cycles.
5. Check the water regulator in the incoming water line.
* Pressure must be 35 - 40 psi (2.4 — 2.75 bar).
6. Verify the cycle completes with no errors.
7. Verify there are no leaks in the reprocessor.
8. Press DISINFECT DUMP and START on the control panel to run a dump cycle. Refer
to the “Disinfection Dump” procedure in the Operation Chapter of this manual
9. After the disinfectant dump cycle is complete, program the disinfectant soak, etc.,
times as needed.
10. Load fresh disinfectant and begin to operate the reprocessor.
Service: __ If the reprocessor cannot be verified, contact Medivators
Technical Support at: 1-800-444-4729 or 1-763-553-3300.
1 2 MM03-0047 Revision D