Medivators DSD-201 - Page 6

REPROCESSING SYSTEMS
NM
Function 52 — Activate Sheath Test Compressor Valve ...................,., 101
Function 53 — Activate Sheath Test Compressor .........................,.. 101
Function 54 — Turn Off All Valves and Reset Latches ....................... 102
Function 55 — Turn Off Sheath Test Compressor ........................... 102
Function 56 — Activate Sheath Test ...................................... 103
Function 57 — Activate Sheath Hold ..................................... 103
Function 60 — Set Default Program ...................................... 104
Function 61 — Set Rinse Drain Time and Disinfectant Drain Time.............. 104
Function 62 — Set Rinse and Disinfectant Fill Times ........................ 105
Function 63 — Set Fluid and Air Purge Times ....................,......... 105
Function 64 — Set Disinfectant Pulse Time ................................ 106
Function 65—SetAddAirTime........................... 0. εν 106
Function 66 — Set Partial Rinse Fill and Drain Times ........................ 107
Function 67 — Set Rinse/Disinfectant Top-Off Times ........................ 107
Function 69 — Set Water Line Disinfect Hold Time ......................... 108
Function 71 — Set Maximum Disinfectant Cycle Count ...................... 108
Function 72 — Reset Programs .......................................... 109
Function 73 — Clear Disinfectant Counter ................................. 109
Function 74 — Set Maximum Reservoir Temperature ........................ 110
Function 75 — Set Minimum BasinTemperature............................ 110
Function 79 — Enable All Sensors ....................................... 111
Function 80 — Set Language ........................................... 111
Function 81 — Set Time Limit .......................................... 112
Function 82 — Set Serial Number ........................................ 113
Function 83 — Program Low Flash ...................................... 113
Function 84 — Program High Flash ...................................... 114
Function 85 — Program Entire Flash ......................,.............. 114
Function 86 — Initialize NVRAM ...................,................... 115
Function 87 — Disable All Sensors ..........,........................... 115
Function 88 — Set Options .................,................,........... 115
Function 89 — Set Station to Idle State ................................... 116
Function 90 — Display Inputs ........................................... 116
Function 91 — Display Cycle Count ενω ων εν νε ρω ενώ νεο εν εκ ων εν 117
Function 93 — Display Temperatures ..................................... 117
Function 94 — Test Sensors ............................................ 118
Function 95 — Test Sheath Tester ....................................... 118
IV
MM03-0047
Revision
D