-15-
1. BATTERY LOADING AND AC ADAPTER LOADING
a. Open battery cover at the back of the monitor.
b. Load four “AA” size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol , replace all batteries with new ones.
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid
significant damage caused by battery leakage.
Avoid getting the battery fluid in your eyes. If it should get in your eyes, immediately
rinse with plenty of clean water and contact a physician.
The monitor, the batteries and the cuff, must be disposed of according to local
regulations at the end of their usage.
d. If you use the AC adapter, please make sure that the monitor is turned off and the
batteries have been removed. Put the connector plug of the adapter into the monitor
socket. Then plug the adapter to AC electrical outlet. To disconnect the AC adapter,
remove the AC adapter from the electrical outlet, and remove the AC adapter plug
SETUP AND OPERATING PROCEDURES
To Next Page
Loading...
Need help?
General
