Foreword
This user manual is intended to provide the necessary information for the proper operation of the model
MS-131002 non-contact infrared body thermometer.
A general knowledge of infrared thermometers and an understanding of the features and functions of
the thermometer are prerequisites for proper use.
The non-contact infrared body thermometer is a medical device designed to last for three years.
Please read this manual before using the thermometer. If you do not fully understand how to use the
thermometer, please consult this manual.
Do not operate the thermometer without completely reading and understanding
these instructions.
Warnings
Warnings are identified by the Warning symbol show above.
• The non-contact infrared body thermometer is to be operated by consumers in the home setting and
primary care setting as a screening tool. The manual, includes directions for use, all precautionary
information and specifications should be read before use.
• This thermometer is designed to measure human body temperature on the forehead. Do not use it for
any other purpose.
• This thermometer is intended to be used as a screening tool in a home setting and a primary care
setting.
• Do not use the thermometer if it malfunctions or has been damaged.
• If the ambient temperature changes too much, such as moving the thermometer from a cold room to a
warm room, allow the thermometer to adjust to the new temperature. This may take up to 30 minutes.
The operating temperature of the thermometer is 59 °F to 95 °F (15 °C to 35 °C).
• Remove the batteries if the thermometer is not likely to be used for a long time.
• The thermometer is not waterproof. Do not immerse it in water or other liquids. For cleaning and
disinfection, please follow the instructions contained in the “Cleaning, Care and Storage” section.
• Do not touch the infrared sensor with your fingers.
02
Safety Information
Notice
Purchase or possession of this device does not carry any express or implied license to use
with replacement parts which would, alone or in combination with this device, fall within the
scope of one of the relating patents.
This device should only be used for the purposes described in these instructions. The manufacturer
cannot be held liable for the damage caused by incorrect application.
The non-contact thermometer is designed to minimize the possibility of hazards from errors in the
software program by following human factors design, risk analysis, and software validation processes.
To Next Page
Loading...