Meec tools 001176 - Replacing Blades

EN
47
CLEANING
• Clean the lawn mower after use.
• Check that the ejector is free from residual
grass and clear if necessary.
– Do not allow grass and other debris
to dry on the surfaces of the lawn
mower. Dry, adhered grass and other
debris can prevent the lawn mower
from working properly.
• Check the underneath of the lawn mower
and the attachment of the blade.
– Put the lawn mower on its right side
(the opposite side to the oil ller
cap).
– Before putting the lawn mower on its
side, empty the fuel tank with a fuel
pump.
– Do not tilt the lawn mower more
than 90°.
MAINTENANCE SCHEDULE
Working
hours
Air lter Spark plug Engine oil
12 Clean Check Check
24 Clean Clean Replace
36 Replace Replace check
STORAGE
SHORTTERM STORAGE
No special preparations are required for
storage less than 2 weeks.
1. Allow the engine to completely cool.
2. Empty the grass catcher.
3. Clean the underside of the mower deck.
4. Store the lawn mower upright on a level
surface.
5. Store the lawn mower out of the reach of
children and unauthorised persons.
there is a lot of dust in the air. Replace the lter
if it is very dirty.
1. Release the clip of the air lter cover and
remove the cover.
2. Take out the lter.
3. Carefully tap the cover against a hard
surface to clean it.
4. Replace the lter in the cover.
5. Place the cover pin in the slot and press in
place.
REPLACING BLADES
WARNING!
• For reasons of safety blades should only
be sharpened and tted by an
authorised service representative or
other qualied personnel.
• Wear safety gloves.
• We recommend inspecting the blade
before use for optimum results.
• Damaged or blunt blades aect the
functionality of the lawn mower.
• If the blades or screws are worn or
damaged, always replace the complete
set to avoid imbalance.
• Always use original spare parts when
replacing blades, fasteners and bolts.
NOTE:
Do not turn the lawn mower upside down,
tilt it on its side towards the oil ller.
1. Hold the blade and undo the hex screw
anticlockwise with a 16 mm spanner.
Remove the washer and blade.
2. Fit a new or sharpened blade on the two
taps on the mounting ange, and lock in
place with the washer and screw.
3. Check that the blade is correctly
positioned and tighten the screw to
45–50 Nm. Do not overtighten.