Meec tools 006295 - Gear Lever; Driving the Wheels

EN
65
drive lever wire and extend the wire one
turn of the nut.
5. If the wheels do not stop moving when
the drive lever is released, loosen the lock
nut on the drive lever wire and shorten
the wire one turn of the nut.
6. Repeat this check and readjust, if
necessary. Tighten the lock nut when you
have nished adjusting.
DRIVING THE WHEELS
1. Allow the engine to run at high speed
and select a suitable gear for the actual
conditions. There are 6 forward gears and
2 reverse gears.
2. Press in to activate the auger, release to
stop the snow blowing.
3. Press in the drive lever to activate driving,
release to stop.
IMPORTANT:
Always disengage, i.e. release the gear lever
before changing gear.
AUGER
The auger lever is placed on the left side of the
handle. Press in the auger lever to start the
auger, release to stop the snow blowing. (The
drive lever must also be released.)
IMPORTANT:
Always check that the auger is working
properly before use. Follow these instructions
carefully and make all the necessary
adjustments to check that the snowblower is
working properly.
Starting the auger
Press the drive lever towards the handle
to engage the wheel drive, then release to
disengage.
GEAR LEVER
The gear selector has 6 positions for driving
forwards and reversing at dierent speeds.
FIG. 8
IMPORTANT:
Always disengage, i.e. release the gear lever
before changing gear.
Forward
The machine has 4 forward gears (F), where 1
is the slowest. Drive at the lowest speed when
snow throwing.
Back
The machine has 2 reverse gears (R), where R1
is the slowest.
Function check
Check the functionality of the drive lever and
gear lever in accordance with the instructions
below.
1. Switch o the engine and put the gear
lever in the position for the highest
forward gear. Release the drive lever
and push the machine forwards. The
snowblower should roll forwards. Press
the drive lever. The wheels should stop
turning.
2. Release the drive lever and push the
snowblower forwards again.
3. Move the gear lever to the position for
the highest reverse gear and back to the
position for the highest forward gear. The
gear lever should move easily and the
wheels should start turning.
4. If the gear lever is sti, of if the wheels
stop moving, loosen the lock nut on the